Valkyrie Riders Cruiser Club
July 09, 2025, 04:10:53 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Drive Shaft to Pinion Cup Seal
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Drive Shaft to Pinion Cup Seal  (Read 1587 times)
Cyclejohn
Member
*****
Posts: 146

Reidsville,N.C.
« on: September 09, 2009, 03:47:47 AM »
Can the drive shaft to pinion cup seal (stopper ring) be re-used or does it need to be replaced every time you do drive line maintenance? Thanks in advance for the advice.           JOHN   
Logged
Daniel Meyer
Member
*****
Posts: 5493


Author. Adventurer. Electrician.

The State of confusion.


WWW
« Reply #1 on: September 09, 2009, 04:46:09 AM »
If it's in good condition it can be reused. If it gets worn it will tend to walk it's way out of position.

I don't change it often (I inspect/clean the pinion cup every 10,000 miles) but I keep one on hand just in case it's needed (cheap part).
Logged
CUAgain,
Daniel Meyer
Cyclejohn
Member
*****
Posts: 146

Reidsville,N.C.
« Reply #2 on: September 09, 2009, 02:24:00 PM »
Thanks Daniel,       John
Logged
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS