Help finding Link/Tool to hold output shaft on reassembly and torque

valknomad

Member

Posts: 61

North idaho

Help finding Link/Tool to hold output shaft on reassembly and torque

« on: February 16, 2016, 08:37:55 PM »

Hydrolock caused tear down of bike. I already have the 32mm socket, 46mm (Clutch) and 36mm (Output Shaft). Starting to Re-assemble, just can't find the Link or (work around tool) to hold "Output Shaft" while torquing.
Manuel states "special tool". Also states 125 ft lb (Indicated) 137 ft. lbs (Actual)... is this correct? Thank You


	Logged

hubcapsc

Member

Posts: 16804

upstate

South Carolina

Re: Help finding Link/Tool to hold output shaft on reassembly and torque

« Reply #1 on: February 17, 2016, 05:20:14 AM »

Find the special tool part number in the manual. Put that number in google.
A ton of places will come out. Probably some of them will be boat places.

I got a whole bunch of Honda special tools (but not the one you need)
that way.

-Mike


	Logged

https://sites.google.com/a/g.clemson.edu/confederate-memorial-day-at-clemson/

98valk

Member

Posts: 13662

South Jersey

Re: Help finding Link/Tool to hold output shaft on reassembly and torque

« Reply #2 on: February 17, 2016, 06:02:54 AM »

u can make your own tool with a 2x4 and some bolts. an impact wrench will make it much, much, easier to do.
http://www.valkyrieforum.com/bbs/index.php/topic,30038.0.html

make sure u follow the tech manual for lbsft.
using a clicker type torque wrench?, when was the last time it was calibrated? a beam type or digital is the way to go.


	Logged

1998 Std/Tourer, 2007 DR200SE, 1981 CB900C 10speed
1973 Duster 340 4-speed rare A/C, 2001 F250 4x4 7.3L, 6sp

"Our Constitution was made only for a Moral and Religious people. It is wholly inadequate to the goverment of any other."
John Adams 10/11/1798

valknomad

Member

Posts: 61

North idaho

Re: Help finding Link/Tool to hold output shaft on reassembly and torque

« Reply #3 on: February 17, 2016, 07:24:23 AM »

The Clutch Basket Assembly/ Shaft is the 46mm / "2x4" tool...
The tool I'm trying to "work around" is to hold the "Output Shaft" / 36mm Locknut.
(it comes off OK with Air Impact Wrench, but Re-assembly... the shaft will need to be held/not spin.)
Thanks


	Logged

hubcapsc

Member

Posts: 16804

upstate

South Carolina

Re: Help finding Link/Tool to hold output shaft on reassembly and torque

« Reply #4 on: February 17, 2016, 08:24:43 AM »

I can only guess from your description (you'd know for sure)
that you need a 07jma-mn50100 or a 07jmb-mn50100.

I just googled them up, they're easy to get from a million
different places...

-Mike


	Logged

https://sites.google.com/a/g.clemson.edu/confederate-memorial-day-at-clemson/

Pages: [1] Go Up

« previous next »