Valkyrie Riders Cruiser Club
July 05, 2025, 02:04:13 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: Turn indicaters not working. SOLVED NO NEED TO CLICK, DUH ME.  (Read 688 times)
Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« on: July 22, 2016, 02:03:06 PM »

Suddenly my turn indicators will not light up or flash, . Front or back. 98 std with light bar. was working on last ride. Any thoughts? Is there a fuse I need to check. Head light good. and fronts come on but not backs. Then when I turn signal to right. The front right goes out and same if I go left. But all the while no rear lights at all. Bulbs checked good on rear.
« Last Edit: July 22, 2016, 02:27:24 PM by Roidfingers » Logged
Hook#3287
Member
*****
Posts: 6446


Brimfield, Ma


« Reply #1 on: July 22, 2016, 02:15:29 PM »

10 amp fuse in the fuse box, but it runs the horn and stop lights too.

Maybe a ground issue?

Maybe turn switch needs attention?
Logged
Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« Reply #2 on: July 22, 2016, 02:26:24 PM »

Thanks Hook, wasn't sure where to look for fuse. That was it.
Logged
bentwrench
Member
*****
Posts: 760

Philadelphia,Pa.


« Reply #3 on: July 22, 2016, 02:32:39 PM »

Did all the t/s stop working at the same time? It's normal for the frt. running lamps to go out during t/s op.
If the fuse is ok,pull the headlamp off and check the gray wire in the 9pin red conn.for pwr to the t/s switch.
the org and blue wires in the same conn go out to the bulbs.If it's not the fuse it's probably the t/s relay.
Logged
Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« Reply #4 on: July 22, 2016, 04:07:25 PM »

What hook said.
Logged
Pages: [1]   Go Up
Send this topic Print
Jump to: