Valkyrie Riders Cruiser Club
July 05, 2025, 10:59:57 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Pages: [1]   Go Down
Send this topic Print
Author Topic: Question on removing Pegs to install Heel to toe shifter and floorboards  (Read 600 times)
vanavyman
Member
*****
Posts: 803


Suffolk, VA


« on: July 31, 2016, 10:37:00 AM »

Hi,
  I have a question on removing the piece of chrome just above the peg on the rear brake side.  It probably is so basic is why I can't find it when searching the 1500 Tech board.  I need to take this piece of chrome off to get the peg off, but I've looked around it and can't find a bolt to release it and I'm leary of pulling too hard.  Can someone give me a pointer. 

Thanks,

Dan
Logged

2015 Red GL1800 Level 4 w/2015 Tailwind Trailer
1999 Valkyrie Custom Interstate w/2006 Bushtec Roadstar Trailer
2000 Valkyrie Interstate Roadsmith Trike (Wife's)
Member Number 33081
Roidfingers
Member
*****
Posts: 729


Tuscaloosa, Alabama


« Reply #1 on: July 31, 2016, 10:50:50 AM »

Is there not a bolt underneath?
Logged
vanavyman
Member
*****
Posts: 803


Suffolk, VA


« Reply #2 on: July 31, 2016, 11:12:49 AM »

Thanks, you are right.  There is a small allen screw on the bottom.  Figured it had to be simple but sometimes simple can be hard to figure out.  Thanks again.

Dan
Logged

2015 Red GL1800 Level 4 w/2015 Tailwind Trailer
1999 Valkyrie Custom Interstate w/2006 Bushtec Roadstar Trailer
2000 Valkyrie Interstate Roadsmith Trike (Wife's)
Member Number 33081
Pages: [1]   Go Up
Send this topic Print
Jump to: