Valkyrie Riders Cruiser Club
June 17, 2025, 01:48:37 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
MarkT Exhaust
Pages: [1]   Go Down
Send this topic Print
Author Topic: Good morning....  (Read 1342 times)
RonBou
Member
*****
Posts: 3025


Farmington, CT


« on: September 13, 2016, 02:20:15 AM »

Logged

Ronbou "Keep the faith!"
Wall
Member
*****
Posts: 1161



« Reply #1 on: September 13, 2016, 04:51:10 AM »

ok, now what? Hmmm, insert part a into part 36,,,,,
Logged

Sometimes you only get 2.7 seconds, make it count.
ybnorml
Member
*****
Posts: 3473


« Reply #2 on: September 13, 2016, 06:53:30 AM »

ok, now what? Hmmm, insert part a into part 36,,,,,

Wait a minute Wait a minute   Wait just a freaking minute
Part #36 used to be part of part # 34, that is until part #34 broke while being pried out of hole # 21.
Best get the Gorilla Glue and throw the instructions away.
« Last Edit: September 13, 2016, 08:24:36 AM by ybnorml » Logged
holmes
Member
*****
Posts: 979



« Reply #3 on: September 13, 2016, 05:27:08 PM »

No, no, no it was Barry in the background saying tighten it until it snaps then back it off a quarter turn
Logged
Wall
Member
*****
Posts: 1161



« Reply #4 on: September 14, 2016, 07:58:59 AM »

No, no, no it was Barry in the background saying tighten it until it snaps then back it off a quarter turn
That just happened at work. They were trying to,,,,,well I really shouldn't say,,, but they were trying to tighten a bolt let's say and asked me to do it cause they needed "just a little bit more." I grab the wrench, gave it a pull, broke the bolt, all hell "breaks" loose, after the situation was rectified the super looked and said "good job Hulk, now go sit down."
Logged

Sometimes you only get 2.7 seconds, make it count.
Pages: [1]   Go Up
Send this topic Print
Jump to: