Anyone with a clutch apart at the moment? Tool question

[Bagger John - #3785]

Looking at the '97-'01 Service Manual (page 9-12), there's a set of holder pins (07VMB-MZ00100, A) mentioned.

These engage holes in the lifter plate.

What is the diameter of those pins, or of the holes in the plate? Alternatively: Are there other Honda holder pins which will work in this application?

Thanks!

[bikerboy1951]

Once you unstake the center nut, all you need is an impact wrench to get the nut off.  We just did a clutch and that is how we removed the center nut.

Brad

[Bagger John - #3785]

No impact wrench @ present. Clutches in both bikes are working fine @ present as well. I just got ahold of a holder plate and am curious about the pins for future use, but not so curious as to spend $214 for a set of 4 new ones...! 

[gordonv]

Since you where talking about the stacked nut on the clutch basket, I'm not sure of the rest, I removed my basket for sale by driving a wedge/awol into the slot and pressing out the stacked section.

Then the right size socket/wrench, and a hammer. Hit the handle in the correct direction, and the nut came off. Motor was out at the time, made it easier.