News:

If you're new to this message board, read THIS!

Main Menu
Inzane 17

Drooping kickstand

Started by .., Sat 08, Jun 2019, 13:31:23

Previous topic - Next topic

..

I can lift it using a bungee cord but in the up position it touches my truck stack.

I have the spare parts with me but can't get anyone to help me until tomorrow in Taos.

Suggestions on another way of holding it up so I can go ride.

Jess from VA

If the bungee holds it too high, stick something in there to hold it off the pipes.

You may have to lean the bike on something to the right, to work on the left.

A zip tie might hold it just where you want it, but will be problem when you want to get off again. 

The fact it is now going up higher than normal may be a problem with the cross member (not just the bolt and the spring).  Hope not. 


..

Sorry.

Bungee touches truck stack.

Jess from VA

Stick something between the bungee and pipe that can be sacrificed, but won't burn or melt.   

..

Quote from: Jess from VA on Sat 08, Jun 2019, 14:32:18
Stick something between the bungee and pipe that can be sacrificed, but won't burn or melt.   

Problem with that is holding everything in place while leaning to the  left and not falling on my ass.

The emperor has no clothes

Quote from: Britman on Sat 08, Jun 2019, 14:09:51
Sorry.

Bungee touches truck stack.
Maybe wrapping some aluminum foil around the bungee ?

WintrSol

Where are you hooking the other end of the bungee? Maybe you can change that - even use a longer one and pull it over your lap? :crazy2:
98 Honda Valkyrie GL1500CT Tourer
Photo of my FIL Jack, in honor of his WWII service

..

Quote from: WintrSol on Sat 08, Jun 2019, 15:41:10
Where are you hooking the other end of the bungee? Maybe you can change that - even use a longer one and pull it over your lap? :crazy2:

Will still touch exhaust plus it would have to be loooong to fit over my lap.

Jess from VA

#8
How far do you have to go to make Taos?

Gas up, zip tie it up (underneath) (or wire), and make a single run?

Not that it's any fun to dead lift, but the bike can be laid on the guards (for work).  It can also probably be leaned on a curb.

I never get off my bike to gas up (or use the kickstand).  You just need to ride in close enough to use the pump and your card (but don't let a hose grab the bars).

..

Quote from: Jess from VA on Sat 08, Jun 2019, 15:47:05
How far do you have to go to make Taos?

Gas up, zip tie it up (underneath) (or wire), and make a single run?

Not that it's any fun to dead lift, but the bike can be laid on the guards (for work).  It can also probably be leaned on a curb.

I never get off my bike to gas up (or use the kickstand).  You just need to ride in close enough to use the pump and your card (but don't let a hose grab the bars).

I'm in Taos. Got here Thursday sick as a dog.

Jess from VA

Well, I'm sorry to hear that.

At least you should be able to get some help with the bike. 

..

Quote from: Jess from VA on Sat 08, Jun 2019, 16:24:22
Well, I'm sorry to hear that.

At least you should be able to get some help with the bike.  

:cooldude:

Punisher and Joe should be here tomorrow. I've decided not to ride in case I lose anything. I have a spring and bolt with me.

Bighead

Hang tough Paul someone will help :cooldude:
1997 Bumble Bee
1999 Interstate (sold)
2016 Wing

ridingron

Use a coat hanger to attach to kickstand. Let it run up over the pipe, it shouldn't melt. Hook the bungee in a loop bent in the end of the coat hanger. Attach bungee where ever works.

Bighead

Quote from: ridingron on Sat 08, Jun 2019, 17:19:46
Use a coat hanger to attach to kickstand. Let it run up over the pipe, it shouldn't melt. Hook the bungee in a loop bent in the end of the coat hanger. Attach bungee where ever works.
I bet Paul has it covered with way more mikes than you with a coat hanger.
1997 Bumble Bee
1999 Interstate (sold)
2016 Wing

Bigwolf

Quote from: ridingron on Sat 08, Jun 2019, 17:19:46
Use a coat hanger to attach to kickstand. Let it run up over the pipe, it shouldn't melt. Hook the bungee in a loop bent in the end of the coat hanger. Attach bungee where ever works.
:cooldude:
I carry a short piece of coat hanger with me just for that reason.

The emperor has no clothes

Quote from: Bigwolf on Sat 08, Jun 2019, 18:21:52
Quote from: ridingron on Sat 08, Jun 2019, 17:19:46
Use a coat hanger to attach to kickstand. Let it run up over the pipe, it shouldn't melt. Hook the bungee in a loop bent in the end of the coat hanger. Attach bungee where ever works.
:cooldude:
I carry a short piece of coat hanger with me just for that reason.
That's a good tip. I will scrounge one up and put it in the trunk.  :cooldude: (I might have to go steal one, ours are all plastic)


I sure was hoping to get over for a day or two and hang with you guys. But, we've got some funky crap going down at work right now.  :tickedoff: Keep that DDT fella in check and don't let him have too much fun.   ;)

MarkT

I modified this brake spring plier specifically to install sidestand springs.  I'll be there with this and a lot more tools tomorrow evening.


Vietnam-474 TFW Takhli 9-12/72 Linebckr II;307 SBW U-Tapao 05/73-4

Jess from VA

Mark, that thing looks like a tool from the Spanish Inquisition.   ;D

..

Had to ride to Walgreens for stronger different anti congestion meds. Kickstand went into full droop mode.  Rode in 3rd holding it up with left heel. Pulled back into Super 8 parking lot and there's the spring on the ground in my parking space!

It's  a strong bugger ain't it.

Cracker Jack

Quote from: MarkT on Sat 08, Jun 2019, 20:23:32
I modified this brake spring plier specifically to install sidestand springs.  I'll be there with this and a lot more tools tomorrow evening.



That puny weld is gonna break!! :o

..

FIXED.

Punisher very kindly did the spannering for me.

Anyone else reading this get the parts and carry them.

9Ball

Quote from: Britman on Sat 08, Jun 2019, 15:44:30
Quote from: WintrSol on Sat 08, Jun 2019, 15:41:10
Where are you hooking the other end of the bungee? Maybe you can change that - even use a longer one and pull it over your lap? :crazy2:

Will still touch exhaust plus it would have to be loooong to fit over my lap.

Where does your lap dog sit?   ;)
VRCC #6897, Joined May, 2000

1999 Standard
2007 Rocket 3
2005 VTX 1300S

..

Quote from: 9Ball on Mon 10, Jun 2019, 05:41:59
Quote from: Britman on Sat 08, Jun 2019, 15:44:30
Quote from: WintrSol on Sat 08, Jun 2019, 15:41:10
Where are you hooking the other end of the bungee? Maybe you can change that - even use a longer one and pull it over your lap? :crazy2:

Will still touch exhaust plus it would have to be loooong to fit over my lap.

Where does your lap dog sit?   ;)

On my knees.