TPMS

[shadowmagic]

So I installed a tiregard TPMS and it seems to be stuck and I'm unable to reset it. Anybody know how to do some sort of hard reset? all batteries are new and I've left the batteries out for half an hour but the same tire pressures appear even with the sensors off and no batteries installed. Any help greatly appreciated.

[TrapperAH1G]

Unit will display the last PSI received until you start riding again.  It sometimes takes a mile or two before the sending units update data and display shows current PSI.

If that's not it, you may have to separate the sensors from the display unit beyond their range.  Last, remove batteries from sending units and display over night.  Reinstall sensor batteries and put them back on stems, then install display battery.

Good luck.

[SunshineNomad]

Mine has done that a couple times. I disconnected and reconnected and they worked.

[shadowmagic]

Thank you for the replies, I will ride it to work and see what happens.

[shadowmagic]

Thank you guys for responding. you guys were right. I rode and it settled in and marked the correct the pressure.