Holes in carburetor slide diphrams

[ckahler]

There are holes in the diaphrams of 2 of 6 carburetors. Can diaphrams be obtained without having to replace the entire slide? I would like to replace all 6 diaphrams, but if I have to pay over $600 for complete slides, I'll only be able to do 2.
Any suggestions on a source for carb parts?

[Gondul#408]

These folks have just the diaphragm...they are a reputable seller in Europe


https://www.valkyrieparts.de/Vergaser-Membran-komplett

[hubcapsc]

I think these guys claim to have what you need for $15 each... I don't
know them...

https://www.amazon.com/Motorbike-Carburetor-Diaphragm-Replacement-1998-2002/dp/B09WVJZ9LB

-Mike

[rug_burn]

Thanks for the info-  That German place looks pretty good, I'm thinking shipping is not going to be cheap, but the quality looks pretty good, like everything German (assuming they're made there.) And it's the whole slide, including the center part.  I want to replace 5 of mine, they don't have holes but have extra pucker where they should be smooth, which could explain some of my bike's weird carb problems.   (one was replaced just recently)

[-mike-]

AFAIK the carb bodies from a 1994-2003 HONDA VF750C Magna are the same as ours on the Valk

I've seen just their carb vac diaphragms for under 10 USD per piece shipped.
Go there:

http://www.jbmindustries.com/index.html

And ask. These guys do know.

Best,
-mike-

[ckahler]

So far I have had no luck finding diaphragms.
I ordered the ones off Amazon that Mike found, but they were too big, 64mm.
Also, partzilla shows 1998 VF750c diaphragm to be 2.5" (63.5mm).
The Valk needs 59.5mm diaphragms. JBM does not have that size.
I did find this listing on e-bay, but they say for 2002 & 2003 model years, and come in a 4 pack?
https://www.ebay.co.uk/itm/284807464230?mkevt=1&mkpid=0&emsid=e11050.m43.l1123&mkcid=26&ch=osgood&euid=fb4bd0d0820c4723bb2046144e4394fa&bu=43372416134&osub=-1%7E1&crd=20230131185147&segname=11050

[98valk]

try small thin layer of rubber cement for the holes.

[hal47]

I don,t think you can just replace the belows,  I would send mitcho a message, if any one knows he would be the one.

[SCain]

ckahler,
If you haven't found any send me an email, I have a couple that I would sell, we can work out the cost + shipping later.
Steve
scain1520@yahoo.com

[ckahler]

Thanks Steve, I sent you an e-mail.