To anyone who has changed a clutch slave cylinder: Can I wiggle it out without removing the side stand bracket? I'm well into Week 2 trying to get that second bracket bolt out. I have a Rivco center stand bracket in the way so I can't use an impact wrench. The bolt screws into the bracket and there's 29 years of rust in there I'm sure. The only wrench that fits into that stupid spot is a crowfoot socket. I'm not looking forward to pulling the rear wheel and swing arm to gain access to cut the bolt head off.
After 30 years I'm ready to button this thing up and sell it. I'm too old to crawl under this thing. On the plus side, if I need an EMT to get off the garage floor Medicare only charges $99.
Thanks all.
