Need help/advice - O-ring on rear wheel -

[Tx Bohemian]

My rear end saga continues.

I notice in the service manual there is an O-ring on the rear wheel, right side between the wheel and driven flange.  After a closer inspection (and cleaning) I see the grove in my wheel, but no O-ring and it looks like it hasn't been there for a good while.
Below is the information copied from "Honda Parts Nation" which will take 7-10 days to get to my house once ordered.

SKU: 91302-MA6-003
O-RING (61X2) (Honda Code 1237213)

Can anyone tell me if the "(61X2)" means the size of the O-ring? Like maybe the diameter and cross-section measurements. Probably in mm.

Has anyone had any luck going to someplace like a bearing supply house and matched up O-rings like this or similar?

My bikes been down for about three weeks now (as soon as I put it up on the lift the sun came out and has been shining ever since) and I really don't want to wait another week for parts unless there is no alternative.

Any other suggestions/comments are appreciated.

Thanks, Al

[Black Dog]

check yer email.

Black Dog

[X Ring]

Here's enough to last you 5 changes.  http://www.carolinabikeandtrike.com/ORings.htm

Marty

[Daniel Meyer]

There are three "O" rings. Make sure and get them all.

http://www.valkyrieriders.com/shoptalk/Elusive%203rd%20O-Ring.htm

[KY,Dave (AKA Misunderstood)]

^^^What he said. ^^^

[Bugslayer]

My rear end saga continues.

I notice in the service manual there is an O-ring on the rear wheel, right side between the wheel and driven flange.  After a closer inspection (and cleaning) I see the grove in my wheel, but no O-ring and it looks like it hasn't been there for a good while.
Below is the information copied from "Honda Parts Nation" which will take 7-10 days to get to my house once ordered.

SKU: 91302-MA6-003
O-RING (61X2) (Honda Code 1237213)

Can anyone tell me if the "(61X2)" means the size of the O-ring? Like maybe the diameter and cross-section measurements. Probably in mm.

Has anyone had any luck going to someplace like a bearing supply house and matched up O-rings like this or similar?

My bikes been down for about three weeks now (as soon as I put it up on the lift the sun came out and has been shining ever since) and I really don't want to wait another week for parts unless there is no alternative.

Any other suggestions/comments are appreciated.

Thanks, Al

I've got four set's of o-rings.  If you would like a set (3 o-rings), you're welcome to it. Shoot me an e-mail with your mailing address.

James

Lubbock, TX.
VRCC# 1128
warthog56@hotmail.com