solid Billet Valve stems - opinions?

[Cliff]

Anybody have experience with these?  Good, bad or indifferent??

http://www.motorcycleanchor.com/tire_valves/index.htm

[chrise2469]

You have to grind down the retaining tab (for the plastic stem holder) on the wheel if you want to use this on the Valk.  It only takes a minute of so, just don't sneeze  while holding the grinder .

I have one on the rear and it appears to be fine, easy to fill and check with a 90 accutire guage. It was done after the last rear tire was changed due to a flat.

Tried to break the front bead with c-clamps but was unsuccessful so will wait until that tire gets swapped before swapping it out.

[1FAST6]

I took mine off and replaced with Patchboy type.  I did not grind the tabs and mounted them facing the left side.  Very difficult to access.  Love the new ones!

[sandy]

I have them on the Valk. Rear has the "T" cut off for a right side fit. Front faces left as I haven't cut the "T" off yet. Much easier access and you don't have to hold the stem while checking pressure.

[1FAST6]

This is what I replaced them with.  $2.50 ea and $2.63 to ship.

http://automotive-hardware.com/1-piece-1-78-chrome-90-inner-mount-tire-valve-p-269.html

[R J]

This is what I replaced them with.  $2.50 ea and $2.63 to ship.

http://automotive-hardware.com/1-piece-1-78-chrome-90-inner-mount-tire-valve-p-269.html

That is what I have also......