Manual for CB/Radio Control

[Andy #7759]

as some of you know, the Interstate was never sold in the EU.
All Bikes here where self imported or via resellers.
Problem that the Manuals are never sold with the bikes.
Who can send me a copy or a download link of the manual for the CB/Radio Control Unit

[2qmedic]

Hello,

To my knowledge, there was never any manual...

The button on the front on the radio control-push untill there is a "CB" on the speedometer panel.

Squech -upper button closest to your left index finger. Adjust to high number to hear only the strongest signals. Adjust to lower numbers allow you to hear progressively weaker signals.

Adjust CB volume - depress the Vol Mode, then adjust the vol.

For external speaker vs helmet intercom - press the lower, most forward button;
     Press down - will change the out put location of the CB.
     Press up, it will change the radio out put location.

Did this by memory, may be only slight varation

Hope this helps

[Bigmac2]

Send me your email and ill send the manual in pdf form also have the install directions rmblaster@sbcglobal.net


Richard (bigmac2)

[gordonv]

Send me your email and ill send the manual in pdf form also have the install directions rmblaster@sbcglobal.net


Richard (bigmac2)

Maybe send a copy to Dag and have posted in Norway?

[Disco]

Maybe send a copy to Dag and have posted in Norway?

+1

[MP]

I believe it has been posted.

MP

[old grouch]

There actually is a separate manual which covers the use/functions of the CB radio.  I have one in front of me.  I do not, however have the capability/skill to get it into a format I can share.  The functions/use of the CB is also covered in the Owner's Manual, which I also have, but as stated can't share.  (see my reply to another post about this same subject, "F6C Interstate Radio Controller" on here, also from a Member in Germany) 
    Stan

[old grouch]

Oh, by the way, I couldn't find the info Dag's site.  May be there, but I couldn't find it!   
    Stan

[old grouch]

You can buy one here:
http://www.repairmanual.com/online/official-2000-honda-gl1500cf-valkyrie-interstate-factory-owners-manual-31mby610/

Stan

[Dag]

You can find a few manuals in the "Valkyrie Document Center" 

http://valkyrienorway.com/download.html

[2qmedic]

Oops, my bad, Never knew of a CB manual. Always learning something new here.
Cheers

[jwebber45]

Send me your email and ill send the manual in pdf form also have the install directions rmblaster@sbcglobal.net


Richard (bigmac2)

Maybe send a copy to Dag and have posted in Norway?

Just checked, The operations manual is different and not listed on Dags site. Maybe you can send it to him so he can post it. Thanks.

[cef2lion]

For radio operation I found a short instruction sheet that helps me. Doesn't Include the CB operation. Someone sent me a PDF on that.

1.  Pwr / Function button - press button to turn on radio and continue to
    press button to select the desired function.  Press and hold until you
    hear a beep to turn radio off (display will show time only).

2.  Volume lever - press up / down to raise / lower volume.  Holding lever in
    up / down position will rapidly increase / decrease volume.

3.  Band / Memo lever - Push up to change between AM and FM.  Push down
    to select stored radio stations.

4a. Tune lever - Push up to increase radio frequency, push down to decrease
      radio frequency.

4b. Seek feature - push lever up or down and release when you hear a beep.
     Seek stops when locating a station with a strong signal.

4c. You can preset 6 AM and 6 FM stations.  System will select stations in order
     they were entered into system.

    1.  To preset a station
      a.  Select AM or FM via the Band / Memo lever (push lever up).
      b.  Push Band / Memo lever down to select desired channel.
      c.  Push Channel Memo button - the CH indicator will begin to blink.
      d.  Push the Tune lever to desired station.
      e.  Push and hold Ch Memo button till you hear a beep.  Indicator will stop
           blinking and preset channel will be visible in the display.
   
    2.  Auto Seek - Press and hold Band / Memo lever down until you hear a beep.
        A. SEL will flash in display, and the system will go into the scan mode for
        several seconds.  It will scan both bands and store the 6 strongest stations
        in each band.  Use Band / Memo lever to select stations.
         
         To turn Auto Select off - press and hold Band / Memo lever until you hear a beep.

5.  Tone control

     A.  To select Bass, push the Audio Mode button until BA appears in the display, then,
          within 4 seconds, push Volume lever up / down to adjust bass level (+6 to -6).

     B.  To select Treble, push the Audio Mode button until TR appears in the display,
          then, within 4 seconds, push Volume lever up / down to adjust treble level
          (+6 to -6).

6.  Fader control

     A.  To balance between front and optional rear speakers, push the Audio Mode
          button until FA appears in the display.  Control volume by pushing the
          Volume lever up / down.
          (The control range: F (front) 9 to F1, 0, R (rear) 1 to R 9).

7.  Ambience (AMB) - Blends and boosts frequencies from both channels for a "live
    performance" effect.  AMB may be used for stereo programs from FM radio.
   The AMB circuit may make a weak FM stereo signals sound worse.

    A.  To use AMB - push Audio Mode button until Ab appears in the display
         (the Ab display may be on or off).  Then, within 4 seconds, change the
         ambience setting.

    B.  To change setting - push Volume lever up (Ab on) or down (Ab off).

8.  Auto Volume Control (AVC) - automatically increase volume as the speed of bike
    increases.

    A.  Push the V-Mode button until AVC appears in the display.  Within 4 seconds,
         adjust the volume by pushing the Volume lever up / down (there are 3
         settings: H (high), L (low), and OF (off).

9.  To switch the CB or Audio system between speaker and headset.

    A.  Push the SPKR/HS lever up to select AUDIO.

    B.  Push the SPKR/HS lever down to select CB.

10. Intercom Volume Control - Note:  some local governments prohibit the use of
    a headset by the operator of a motor vehicle.  The intercom system may be
    used to communicate with your passenger.

    A.  To adjust intercom volume, push the V-MODE button until the headset
         indicator appears in the display.

    B.  Push the Volume lever up / down to adjust the volume (note - intercom
         is hot mike, always on).

Clock

Turn the key on or to ACC> Radio ON > Push and hold the CLOCK button until you hear a beep and the

display starts blinking > Operate the VOLUMN lever to adjust the time, push the volumn lever up and

hold it until you reach the desired hour, then push the volumn lever down and hold it until you reach

the desired minute > Push the CLOCK button again to lock in the time display.

[Andy #7759]

Thank's for your help my Friends. 
Problem solved.
Merry X-mas to everybody