In need of pilot jet tool

[Buckaroo]

Any advice as to where to acquire one of those right angle pilot "D" tools?. I made one out of a shell for bench work but is too tall to get into a running bike. 

Nice to be back in Valkyrie World...It has been several years. Never should have sold the 1st one...

Buckaroo

[Madmike]

Here's the tool that you are asking about: the "D" bit is available by itself if you want just that

http://www.motionpro.com/motorcycle/partno/08-0229/

Here is a sync tool that they are selling, I think it is new for them, mixed reviews from users, will do up to 4 cylinders at once:

http://www.motionpro.com/motorcycle/partno/08-0411/

[hubcapsc]

I got the "Warning -while you were typing..." message, but here goes anywho 

http://www.motionpro.com/motorcycle/partno/08-0242

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=94011

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=95320

-Mike

[Marty_in_MN]

I picked up the MotionPro tool from Chaparral Motorsports (P/N: MP08-0242).

Their price is right, $2.90, but the problem was that it was backordered for a long time. I just received it today, and I ordered it on 05/22/09!