Corbin side covers

[Joevalk]

Does anyone have any pics of the mounting brackets? Seams my painter has misplaced them. Still posses I won't be at the GOTFs

[Joevalk]

http://www.quexpress.02hosting.com/quexpress/Valkyrie/side_cover.htm

Found some info

[Dusty]

 Did you get enough info . I have one in the garage that I can take a picture of if you need it. Let me know

Dusty

[Joevalk]

Measurements would be more helpful, I may have to make my own
And pics too. Thanks

[Dusty]

 For the right side cover(when sitting on the bike) there is a bolt, lock washer, 2 rubber washers, a sleeve that slides over the bolt, a nylock nut and a chrome nut.

The bolt is metric so I will give metric sizes and  conversions    6mm x 1 mm pitch x 50 mm long  threaded all the way to the end of the bolt. hex head is 10 mm
Bolt diameter in inches is .230 " x  1.961 long . hex head is 3/8"

rubber washers are 1/4" hole x 5/8" outside diameter x 3/32" thick each

Metal sleeve is 1/2" od x 1/4" hole x 1" long      material steel.

Acorn nut is 11 mm hex 16mm long     

Acorn nut is 7/16" hex and 5/8" long.

I don't know where the bracket is for the left side cover so I sent an e-mail to a friend to measure his. I will post up the rest of the info when I get it.  Any questions?

Dusty

[Dusty]

Joevalk

I talked to Normand (Quexpress) and he says the hardware is the same for both sides. So just double up on the right side hardware and your good to go.

Dusty   

[Joevalk]

Have you ever missed placed something, right where you left it? Well I have. Found my mounting hardware in  drawer I forgot.