Ultrasonic Cleaned Carbs

[PharmBoy]

My '99 I/S had never had the carbs off and I had become a little worried about the condition of all those rubber o-rings.  After removing the carbs I hustled them off to Tulsa to Attic Rat's place where they were quickly disassembled and all parts put in his new ultrasonic cleaner three at a time covered in Krud Kutter Parts Washer.  They were then rinsed with water and dried with an air hose.  Every part was again like new, (aluminum, brass, rubber, & bakelite).  I just can't say enough good things about this system and Attic Rat's (Bob Smith) attention to detail while dealing with these carbs. (He's also a damn nice guy!)

[dancnman]

Looks nice.

[Attic Rat]

Thanks Jim they do clean up better with the ultrasonic cleaner than they ever did in the carb vat