houston area shop

[turtle254]

Anyone know for good shop a round Houston to do a tune up for the carburetor's

[Gental Gaint]

No..... but, that's why I'm making the trip to Canton, TX to see my V4 Honda buddy Billy C... he is the V4 carb guru with OVER 3000 carb rebuilds to his name... do you want me to take your carbs up too....???? 

[turtle254]

Thanks, but got a date with Attic Rat for a rebuild.
Mines a V6 (1998) Should post his name here on forum,
everybody needs help with carbs.

[Gental Gaint]

Thanks, but got a date with Attic Rat for a rebuild.
Mines a V6 (1998) Should post his name here on forum,
everybody needs help with carbs.

WHAT..... you have one of those VERY rare v-6 Valks....... How bad are yours...???? Billy cleaned mine in about 90 minutes..... I talked to Bob about rebuilding mine... Ijust didn't like the 1/2 year WAIT............ call me.... let's TALK..........

[Gental Gaint]

OK... I don't have a dog in this fight... just passing along some GOOD info...........


                                   

Hey guys... there's a new guy rebuilding Valk carbs now... Billy Carr in Canton, Tx.... he has done over 3000 sets of Honda v4 carbs and just got finished with my carbs... look him up on eBay... fngster..... phone is 903 567 1543 or 903 340 6009... call him.... FYI... Honda didn't look very hard to find a set of carb's for the 1500 Valk's............ There 3rd. GEN Honda Magna carbs so all Honda did was to add a middle carb.... Billy already has 99% of all the needed O-rings and SS screws and might already have a supplier lined up for the vacuum diagrams...

The USPO dropped off 3 set's of v-4 carbs this morning... but since I drove 4 hours to see him, I got bumped to the front of the 'rebuild line'....

[98valk]

Honda didn't look very hard to find a set of carb's for the 1500 Valk's............ There 3rd. GEN Honda Magna carbs so all Honda did was to add a middle carb....

thanks for that info. always good to know what other Honda parts were used and fit.

[Tx_Nomad]

If you haven't had the service done yet, check out Barnett Cycles in Splendora, about 30-40 miles north of I-10 off Hwy 59.