VRCC Calendar Ad

Supercharging the Dragon!!!!!

Started by valkrydrNhawaii, Fri 30, Sep 2011, 00:46:15

Previous topic - Next topic

valkrydrNhawaii

I did ask this in the General Board didn't get too many responses, but I do appreciate the ones I did get. I know there used to be a LaMonster Supercharger kit for these beasts, but is it still available. The website I found doesn't have much information, nor does it have a buy me option. www.magnacharger.us is where I was looking, is there a different site I should be looking at, or are the kits just non-existant anymore? I am looking at next year to pick one up, if they happen to be still around. I appreciate the help, and as always keep the rubber side down, while your knees are in the breeze.

Aloha,

Mike "Valkrydrnhawaii"

tank_post142

contact one of the supercharged owners here. expect to pay $100-125 per hp plus some custom fab work. it would appear most spend between $3500 and $5000 to pick up 30hp.
I got a rock :(
VRCCDS0246 

X Ring

While you're at it contact RM Enterprises for a belly tank.  You're going to need the extra fuel capacity to feed that beast.

Marty
People are more passionately opposed to wearing fur than leather because it's safer to harass rich women than bikers.           

R J

If ya'll is from Hawaii, where do you plan to use that extra Horsepower.

When I was over there the top speed limit I saw was 35, and that was on H-1.

I rode a Hardley all around the island of Oahu, and never found a road long enough or straight enought to open the Hog up.

Just curious here.
44 Harley ServiCar




 


tmfp

My dyno man reckons that, for about £1800 ($2600), he can fit twin Saab turbos and do the fabrication, pipework etc. to give up to 300 bhp.

Fudd

Quote from: tmfp on Fri 30, Sep 2011, 12:20:18
My dyno man reckons that, for about £1800 ($2600), he can fit twin Saab turbos and do the fabrication, pipework etc. to give up to 300 bhp.
Man, go for it.  Then publish the dyno results.  I'd really like to see that.


Save a horse, ride a Valkyrie

tmfp

There are two downsides that I can see.
1) As each bank of cylinders would have its own turbo, everything must be matched up exactly or the crank will twist.
2) It would kill me. Or, rather, I would kill myself with its help.

He was fine tuning a turbo'd 'Busa today, road bike, 306 bhp at the back wheel.

BonS

Two Brothers Racing did this twin supercharger setup . . .


dago mooserider

My bike isn't supercharged, so I can only regurgitate what i've read on this board. As far as I know they are still available although I doubt they are selling any lately because of the inability to take out any timing. The dyna module is what was discontinued and so there is no feasible way to retard timing under boost. If you supercharge and keep the stock timing bad things will happen. You could maybe get away with stock timing if you ran 100+ octane all the time and kept the boost under 5-6 lbs, but thats only a maybe. I'd love to supercharge or even turbo if there was a way to keep the cost reasonable and keep the bike at least semi-reliable.


Quote from: tmfp on Fri 30, Sep 2011, 12:20:18
My dyno man reckons that, for about £1800 ($2600), he can fit twin Saab turbos and do the fabrication, pipework etc. to give up to 300 bhp.

Hell I'd fly my bike across the pond that.... :)  I'm sure he means the tubos will support 300 h.p. Unfortunately our flat sixes won't, pistons, crank, rods would all have to be replaced/ugraded. 200 might be a realistic goal. Some on this board have gotten over 160 h.p. supercharging, but it required lots and lots of time and money.
98 valk, 2000 valk, 04 gsxr 750, 85 atc250r, 88 trx250r, 97 expedition (it's indestructible!), 12 civic si, 16 acura tlx, 18 f150.

BonS

I know of at least one supercharged Valkyrie that runs with a standard ignition module and always uses an octane booster to avoid detonation. I'm told that is costs an additional 30 cents per gallon, forever, but it's a solution for that missing Dyna 3000.

tank_post142

this one is not that much more than the cost of a blower set up on your bike:
http://newjersey.craigslist.org/mcy/2581612675.html
I got a rock :(
VRCCDS0246 

tmfp

If that bike was in the UK, I'd be knocking his door down!

Imohtep

#12
Quote from: tmfp on Wed 05, Oct 2011, 10:02:25
If that bike was in the UK, I'd be knocking his door down!

Looks little bit like mine  :)



http://vrcc.photostash.com/vrcc_32485/MIMG_1492.jpg

Valk with supercharger...that's it!
#32485

tmfp

A beautiful bike, my Finnish friend, I think you may want more than 5000 euros for her, though....

wekieboom

#14
I am no mechanic or expert... but, I have heard good things about Bill, from magnacharger, and even mpg increase on the supercharger application using a Mikuni carb, different than the earlier setups.  I even talked to Lamonster and confirmed that people have increased MPG to mid 30's (I say increased as I get 30 on a good day after 6to6 pipes and jetting the carbs).  They also said that they have made some modifications to lower the operating temperature, and thus air, to reduce detonation and said premium gas from the pump is fine.

again... I am not a professional... just really want to throw one on while we are remixing my valk (smaller finders, sissy bar, progressive rear shocks, +6 rake on the front, 200 series rear tire, redoing the seat and seating bracket, and much more...I would show our progress but don't know how to insert picture  ;D) so I have done some snooping.  

Let me know if anyone has some first hand experience of functionality of the newer supercharger they are putting out, I have only heard good things!

And if you are interested contact the company, Bill emailed me back quickly with info.
< boom >

wekieboom

#15
photo upload testing.... :o... looks like that worked!

My pretty Valk all naked


Slicks work the best for tires...



with the latest work, waiting on the trees to come then we will custom order shocks to get height right


good to see the chopping we have done
< boom >

dago mooserider

I've been mulling over supercharging or possible nitrous for awhile but, I'm gonna have to sell something first to keep from getting divorced  ;D  I just bought a 200 tire for the rear as well. My old 180 looked like yours. Burnouts are soooo fun.....
98 valk, 2000 valk, 04 gsxr 750, 85 atc250r, 88 trx250r, 97 expedition (it's indestructible!), 12 civic si, 16 acura tlx, 18 f150.

tmfp


wekieboom

< boom >

holderd

wekieboom
Keep posting pictures as you progress. I think you may be taking your Valk in the direction I want to take mine.

wekieboom

Here she is with some flat black and with the new triple trees to give it a plus 6 rake and with exhaust wrapping...

< boom >

wekieboom

Probably still going to wait a while on the supercharger...  :'(
< boom >

tmfp

Looking good, is that an AME set of yokes?

wekieboom

#23
Not AME, have his info at home, will post if I find it.  Took a little more than a month to get them made and sent but look great (IMO)!  

Found him : http://www.xf6-custom.com/partpages/tripletree.html
< boom >

bambam625

Quote from: wekieboom on Sat 19, Nov 2011, 13:01:51
Here she is with some flat black and with the new triple trees to give it a plus 6 rake and with exhaust wrapping...



that thing is freaking beautiful. I tried contacting magna about their super charger, but that was almost a week ago and they havent responded. Hoping theres still some available.