News:

If you're new to this message board, read THIS!

Main Menu
Inzane 17

Bike Sat 5 years

Started by trout dude, Wed 05, Feb 2014, 17:46:06

Previous topic - Next topic

trout dude

Skinhead
    Yes every thing looked good and was well with in tolerance when checked.
 Dennis

trout dude

Well I got all the parts to start putting the clutch back together. While I was cleaning all the parts for the last time i did find another plate cracked so I had my buddy over night it and now have it all.
I'm going for a ride tomorrow and will start putting the ole girl back together in the evening when I get back.
  Dennis

Mr.BubblesVRCCDS0008

Did my own clutch rebuild at 160,000. replaced all fiber dics and metal dics too. Took an afternoon but not hard at all.

JimmyG

Hope all goes well Dennis.

trout dude

I would like to thank everyone who helped me with the big fix. I took the old gal on the hwy this morning and ran her about 20 miles (all i could stand 38 degrees 20 mile an hour wind and no windshield). Still have some fine tuning to do but motor, clutch did real well. Will post when it is all done. Still have a lot of cleaning and like I said fine tuning.
 Thanks Dennis

Skinhead


Friendsville, TN - Troy, MI

T-Bird

Quote from: trout dude on Mon 03, Mar 2014, 14:27:58
I would like to thank everyone who helped me with the big fix. I took the old gal on the hwy this morning and ran her about 20 miles (all i could stand 38 degrees 20 mile an hour wind and no windshield). Still have some fine tuning to do but motor, clutch did real well. Will post when it is all done. Still have a lot of cleaning and like I said fine tuning.
 Thanks Dennis

Gee Dennis, it was nothing, call me anytime you need mechanical advice... or you need to get rid of some pralines. :evil:

T-Bird

I almost got between you and Sheila for inzane buddy :evil:

trout dude

T-Bird
  She made some last night I thought about you and yes you did and I thought that was funny.
She is going to make some at GOTF so you will get some soon enough buddy. :cooldude:
   Dennis

hal47

Dennis on my harley I just put back two steel plates to replace the riveted one, couldn't tell any difference,just measure and make sure they are the same thickness.

trout dude

Thanks Hal
  Shelia got to take her out yesterday for a little spin and said she loved it and wanted to go again today but it was raining. We will see what happens tomorrow when she gets home.
 Dennis