Front turn signals install on an IS, got to be a easier way?

[bt24]

Good evening,
I tried to search for a thread on front turn signal install on a IS with no luck, if there is already at thread I apologize.

My question is, is there an easier way to get to the bolts to undo the Front turn signals install on an IS fairing? Impossible to reach, got to be a easier way?

Thank you in advance!
Bryan

[Hook#3287]

I'm new to the Interstate world, but it appears you have to remove the fairing to get to them.  That's what I did, but I was removing it anyways, to fix just about everything.

[bt24]

I'm new to the Interstate world, but it appears you have to remove the fairing to get to them.  That's what I did, but I was removing it anyways, to fix just about everything.

Yep I was hoping I wouldn't have to do that, thank you for the feedback!

[Bighead]

Not very hard to remove. Just tame your time

[gordonv]

I believe it is as easy as removing the inner fairing, so you can get to the 2 bolts/2 nuts holding the fairing to the Triple Tree (TT). Unplug the wire and lift it away. Easier with 2 people but I did it with one. I had to remove the windshield also, so I had gone further.

[bt24]

I believe it is as easy as removing the inner fairing, so you can get to the 2 bolts/2 nuts holding the fairing to the Triple Tree (TT). Unplug the wire and lift it away. Easier with 2 people but I did it with one. I had to remove the windshield also, so I had gone further.

Well thanks for the advise, I did take the fairing and the windshield off and cleaned it all up then removed the old and installed the new one's.

Thanks again,
Bryan