Adding Std/Tourer Light to perm Supervalk....remaining wire?

[Stick]

so bought the two harness but the final wire? can someone save me some time and point me to where i tap into and which wire? seems like must be for brake light as all signals work and running light no brake.

[gordonv]

so bought the two harness but the final wire? can someone save me some time and point me to where i tap into and which wire? seems like must be for brake light as all signals work and running light no brake.

Refresh our memory, are you referring to the std/tourer 2 sub harnesses, A & B?

I recall looking to do this, and they plug into the same place onto the main wire harness, if my memory is correct.

[Stick]

yes i ordered the two std/tourer harness to replace the interstate ones and they all plug in but i am left with one wire that has no receptacle i remember someone saying this just wondered if i can be directed to good location and wire to tap into

[John Schmidt]

It would help if you ID'd the wire color for us.

[Stick]

green/yellow

also there will be no trunk going back on original IS signal and brake light harness removed

[John Schmidt]

green/yellow

also there will be no trunk going back on original IS signal and brake light harness removed

That's the brake wire.

[Stick]

yes so where is best place to tap into it?

green/yellow

also there will be no trunk going back on original IS signal and brake light harness removed

That's the brake wire.

[Stick]

ok so is that plug under siade cover in same rubber sleeve that bullet connectors are in , is that where i grab the wire i need?

man i thought tons of people have done this...help please..lol?

[gordonv]

I would get a 3 pin connector to plug into the one you unplugged the trunk from, and connect there.

Those sub harness from the std/tourer, they are single wires plugged into bullet connectors?